We install quality American Standard Heating and Air Conditioning Equipment.
We install more American standard heating and Air
Conditioning Equipment than any other dealer in Southern California. The
reason is value. The equipment is top notch and so are our service
professional. You will receive a clean, neat well performed job. Our service
technicians are factory trained in addition to our own in house training.
American Standard is the best of the best. Don't believe me-check us out. A
national leading consumer publication has this to say.
Click Here.
Residential Electric Only Heat Systems(click for more information)
Forced air electric heat
strips and radiant ceiling heat. We work on these every winter.
The codes have changed over the years and they
have not favored electric only heat. This includes heat strips or electric
radiant heat. This is not heat from a heat pump. The State of California no
longer allows electric heat as the primary source of heat. The heat from the
electric only source cannot exceed 10% of the full load and can only be used
as back up. This is without regard to the existing system in the home. We
cannot replace an electric only heater with a like product. A heat pump
system must be installed. Electric ceiling radiant heat cannot be repaired
when the wiring breaks (it is no longer manufactured) and therefore an
alternate heating system is required. Give us a call and we will come to
your home or place of business and give you the options that you do have.
What does Efficiency and SEER mean?
This is the ratio of the number of btu's of cooling compared
to the amount of electricity used. The higher the seer rating the less that
the unit will cost you to operate. For more information click here.
Maintaining Efficiency
When Replacing
Here is what that low bidder is doing to
cut corners, Educate yourself and get the system that you think you are
buying.
Maintaining Efficiency After Replacement
System neglect is the second most common reason for system failure. See
what you can do to prolong the life and efficiency of your new and current
system.
R22 and R410A. What is the difference?
There is quite a bit of confusion about the new Freon R410A.
It is not more efficient. It is not less efficient. It is simply different.
It operates at a higher pressure than R22 (200-300psi vs. 400-550psi). Nearly
every manufacturer is switching to R410a because of EPA regulations. R410A
is not suppose to damage the ozone layer. Carrier Corp. has named R410a "Puron"
for marketing purposes. It is the same product, the name is only hype for
marketing purposing. I think that it is shameful.
If I get an R22 system now, will the Freon be banned like
what the government did with cars?
NO. Don't worry about it. R22 Freon will be around far longer
than the normal lifespan of your equipment. There are no large taxes that
are currently being contemplated for R22 like what was done with cars.
Sound Control. Is your heating and air
conditioning system driving you to no sleep? we install the quietest systems
available. We can quiet down your existing system. It is quick and easy and
can be performed at any time. Give us a call and see what we can do.
